Brocade Fabric OS Encryption Administrator’s Guide Support Uživatelský manuál stáhnout pdf (Strana 100)

82 Fabric OS Encryption Administrator’s Guide (KMIP)

53-1002747-02

Adding target disk LUNs for encryption

You can add a new path to an existing disk LUN or add a new LUN and path by launching the Add

New Path wizard. To launch the wizard, complete the following steps:

Before you can add a target disk LUN for encryption, you must first configure storage arrays. For

more information, refer to “Configuring storage arrays” on page 87.

1. Select Configure > Encryption from the menu task bar to display the Encryption Center

dialog box.

2. Select a group, switch, or engine from the Encryption Center Devices table, then select

Group/Switch/Engine > Disk LUNs from the menu task bar.

The Encryption Disk LUN View dialog box displays (Figure 73).

FIGURE 73 Encryption Disk LUN View dialog box

The dialog box provides a convenient way to view and manage disk LUNs that are provisioned

from different hosts, identify conflicts between configuration policies on storage systems, and

to provide a launching point for the Add New Path wizard for configuring multiple I/O paths to

the LUN.

The dialog box contains the following information:

• Storage Array selector: Determines which LUN paths are displayed in the table. Enables

you to select a storage array from the LUN view prior to launching the Add New Path

wizard. Only ports that belong to at least one target container are listed.

• Host selector: Used to select a host from the LUN view prior to launching the Add New Path

wizard. Only ports that belong to at least one target container are listed.

• Encryption path table: Should be LUN/Path identified by the following:

• LUN Path Serial #

• Target Port

• Initiator Port

• Container Name

• Switch Name

• Fabric

• State

• Thin Provision LUN

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 321 322

Žádné komentáře

Brocade Fabric OS Encryption Administrator’s Guide Support Uživatelský manuál Strana 100