Brocade Fabric OS Encryption Administrator’s Guide Support Uživatelský manuál Strana 66

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 332
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 65
46 Fabric OS Encryption Administrator’s Guide (DPM)
53-1002922-01
Adding a switch to an encryption group
2
Adding a switch to an encryption group
The setup wizard allows you to either create a new encryption group, or add an encryption switch to
an existing encryption group. Use the following procedure to add a switch to an encryption group:
1. Select Configure > Encryption from the menu task bar to display the Encryption Center
dialog box. (Refer to Figure 6 on page 14.)
2. Select a switch to add from the Encryption Center Devices table, then select Switch >
Create/Add to Group from the menu task bar.
NOTE
The switch must not already be in an encryption group.
The Configure Switch Encryption wizard welcome screen displays. (Refer to Figure 29.)
FIGURE 29 Configure Switch Encryption wizard - welcome screen
3. Click Next.
The Designate Switch Membership dialog box displays. (Refer to Figure 30.)
Zobrazit stránku 65
1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 331 332

Komentáře k této Příručce

Žádné komentáře