Brocade MLX Series and NetIron Family (Supporting Multi-Se Uživatelský manuál Strana 15

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 62
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 14
Brocade MLX Series and NetIron Family Documentation Updates 7
53-1003301-07
Telemetry Solutions
1
Global level configuration
Configuring System max and cam-partition
system-max vlan 4095
system-max virtual-interface 4095
system-max ip-filter-sys 40960
system-max receive-cam 512
system-max ipv4-mcast-cam 512
system-max ipv6-mcast-cam 512
cam-partition profile ipv4-ipv6
Disabling LFS at global level
no link-fault-signaling
link-fault-signaling ignore-rx
link-fault-signaling ignore-rx device-1
NOTE
These commands prevent link-fault-signaling (LFS) from taking the tap ports offline due to LFS on
the monitored links
Configuring Ingress tap port
interface ethernet 1/1
enable
ip policy route-map Outer_Mall
ipv6 policy route-map Outer_Mall
allow-all-vlan pbr
gig-default neg-off
mac access-group Deny_Any out
NOTE
gig-default neg-off is required to be configured only for 1G fiber ports.
Configuring Egress port
interface ethernet 13/1
enable
link-fault-signaling
link-fault-signaling ignore-rx
interface ethernet 13/2
enable
link-fault-signaling
link-fault-signaling ignore-rx
interface ethernet 13/3
enable
link-fault-signaling
link-fault-signaling ignore-rx
NOTE
LFS must be enabled on Egress 10G ports.
Zobrazit stránku 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 61 62

Komentáře k této Příručce

Žádné komentáře