Brocade Multi-Service IronWare Multicast Configuration Gui Uživatelský manuál stáhnout pdf (Strana 117)

Multi-Service IronWare Multicast Configuration Guide 105

53-1003032-02

Configuring DVMRP

The report shows the following information:

This field Displays

Version The DVMRP version operating on the router.

Probe Interval The frequency in seconds at which neighbor probe messages are sent

to the ALL-DVMRP-ROUTERS IP multicast group address. Possible

values are 5 to 30 seconds. The default value is 10 seconds. This

parameter is configured in “Modifying probe interval”.

Neighbor timeout The period of time in seconds that a router will wait before it defines an

attached DVMRP neighbor router as down. Possible values are 60 to

8000 seconds and the default value is 180 seconds. This parameter is

configured in “Modifying neighbor timeout”

Graft Retransmit Interval The initial period of time in seconds that a router sending a graft

message will wait for a graft acknowledgement from an upstream router

before re-transmitting that message. Subsequent retransmissions are

sent at an interval twice that of the preceding interval. Possible values

are 5 to 3600 seconds and the default value is 120 seconds. This

parameter is configured in “Modifying graft retransmit time”

Prune Lifetime or Age The period of time in seconds that a prune state will remain in effect for

a source-routed multicast tree. After the prune age period expires,

flooding will resume. Possible values are from 20 to 3600 seconds. The

default value is 180 seconds. This parameter is configured in

“Modifying prune age”

Maximum Routes The maximum number of DVMRP routes allowed on the router.

Active Route Count The number of active DVMRP routes.

Route Expire Interval The time period in seconds during which a route is considered valid in

the absence of the next route update. Possible values are from 20 to

4000 seconds and the default value is 200 seconds. This parameter is

configured in “Modifying route expires time”.

Route Discard Interval The time period in seconds before a route is deleted. Possible values

are from 40 to 8000 seconds and the default value is 340 seconds.

This parameter is configured in “Modifying route discard time”.

Route Report Interval The time interval in seconds between which the router propagates its

complete routing table to other neighbor DVMRP routers. Possible

values are from 10 to 2000 seconds and the default value is 60

seconds. This parameter is configured in “Modifying report interval”.

Trigger Update Interval The time interval in seconds between which the router sends trigger

updates which reflect changes in the network topology. Possible values

are from 5 to 30 seconds and the default value is 5 seconds. This

parameter is configured in “Modifying trigger interval”

Maximum Mcache The maximum number multicast cache entries for DVMRP allowed on

the router.

Current Count The number of multicast cache entries currently used.

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 215 216

Komentáře k této Příručce

Žádné komentáře

Brocade Multi-Service IronWare Multicast Configuration Gui Uživatelský manuál Strana 117

Komentáře k této Příručce

Související produkty a manuály pro Počítačové příslušenství Brocade Multi-Service IronWare Multicast Configuration Gui