Brocade FastIron Ethernet Switch Stacking Configuration Gu Uživatelský manuál stáhnout pdf (Strana 111)

8 S FCX648 active 0000.0077.7980 128 local Ready

active standby

+---+ +---+ +---+

-2/1| 8 |2/2--2/2| 3 |2/1--2/1| 5 |2/2-

| +---+ +---+ +---+ |

| |

|-------------------------------------|

Standby u5 - No hitless failover. Reason: hitless-failover not configured

Displaying pending device roles

When hitless stacking is disabled, a priority change will trigger an election, but the newly-elected winner

will not assume its role until the entire stack is reloaded or hitless stacking is enabled.

You can use the show stack command to view pending device roles. The “Role” column displays the

current role for each unit. The “Comment” column displays the role that will take effect after a reload or

when hitless stacking is enabled.

device#show stack

alone: standalone, D: dynamic config, S: static config

ID Type Role MAC Address Pri State Comment

2 S FCX648S member 0000.0000.0000 0 reserve

3 S FCX624 standby 0000.0076.2640 200 remote Ready, active if reloaded

5 S FCX624 member 0000.0000.0400 128 remote Ready, standby if reloaded

8 S FCX648 active 0000.0077.7980 128 local Ready, member if reloaded

active standby

+---+ +---+ +---+

-2/1| 8 |2/2--2/2| 3 |2/1--2/1| 5 |2/2-

| +---+ +---+ +---+ |

| |

|-------------------------------------|

Standby u3 - No hitless failover. Reason: hitless-failover not configured

Hitless stacking failover

Hitless stacking failover provides automatic failover from the active controller to the standby controller

without resetting any of the units in the stack and with sub-second or no packet loss to hitless stacking-

supported services and protocols.

For a description of the events that occur during a hitless failover, refer to “What happens during a

hitless stacking switchover or failover.”

For a description of this feature’s impact on major system functions, refer to “Supported hitless stacking

protocols and services.”

For an example of hitless failover operation, refer to “Hitless stacking failover example.”

For feature limitations and configuration notes, refer to “Hitless stacking configuration notes and feature

limitations.”

Enabling hitless stacking failover

To enable hitless stacking failover, enter the following command at the global CONFIG level of the CLI:

device(config)# hitless-failover enable

The command takes effect immediately. Hitless switchover is allowed, and in the event of a failover, the

standby controller will take over the active role without reloading the stack.

Syntax: [no] hitless-failover enable

Use the no form of the command to disable hitless stacking once it has been enabled.

Displaying pending device roles

FastIron Ethernet Switch Stacking Configuration Guide 109

53-1003090-02

1 2 ... 106 107 108 109 110 111 112 113 114 115 116 ... 159 160

Komentáře k této Příručce

Žádné komentáře

Brocade FastIron Ethernet Switch Stacking Configuration Gu Uživatelský manuál Strana 111

Komentáře k této Příručce

Související produkty a manuály pro Počítačové příslušenství Brocade FastIron Ethernet Switch Stacking Configuration Gu