Brocade Multi-Service IronWare Routing Configuration Guide Uživatelský manuál stáhnout pdf (Strana 321)

100

101

Multi-Service IronWare Routing Configuration Guide 293

53-1003033-02

Displaying IPv4 IS-IS information

Displaying the IS-IS configuration in the running-config

You can display the global IS-IS configuration commands that are in effect on the Brocade device

using the following CLI method.

NOTE

The running-config does not list the default values. Only commands that change a setting or add

configuration information are displayed.

To list the global IS-IS configuration commands in the Brocade device’s running-config, enter the

following command at any level of the CLI.

Brocade# show isis config

router isis

net 20.00e0.5200.0001.00

end

The running-config shown in this example contains the command that enables IS-IS and a

command that configures a NET.

To display the interface configuration information in the running-config, enter one of the following

commands at any level of the CLI:

• show running-config

• write terminal

Syntax: show isis config

Global Hello Padding This value can be:

• Enabled

• Disabled

Global Hello Padding For Point to Point

Circuits

This value can be:

• Enabled

• Disabled

Ptpt Three Way HandShake Mechanism This value can be:

• Enabled

• Disabled

IS-IS Traffic Engineering Support This value can be:

• Enabled

• Disabled

BFD This value can be:

• Enabled

• Disabled

Interfaces with IPv4 IS-IS configured Interfaces on which IPv4 IS-IS is configured.

TABLE 39 IS-IS neighbor information (Continued)

This field... Displays...

1 2 ... 316 317 318 319 320 321 322 323 324 325 326 ... 845 846

Komentáře k této Příručce

Žádné komentáře

Brocade Multi-Service IronWare Routing Configuration Guide Uživatelský manuál Strana 321

Komentáře k této Příručce

Související produkty a manuály pro Počítačové příslušenství Brocade Multi-Service IronWare Routing Configuration Guide