Brocade Network OS NETCONF Operations Guide v4.1.1 Uživatelský manuál stáhnout pdf (Strana 551)

100

101

Network OS NETCONF Operations Guide 519

53-1003231-02

Chapter

Configuring OSPF

In this chapter

•OSPF configuration with NETCONF overview . . . . . . . . . . . . . . . . . . . . . . . . 519

•OSPF over VRF . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 520

•OSPF in a VCS environment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 520

•Performing basic OSPF configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 523

OSPF configuration with NETCONF overview

Open Shortest Path First (OSPF) is a link-state routing protocol that uses link-state advertisements

(LSAs) to update neighboring routers about its interfaces. Each router maintains an identical

area-topology database to determine the shortest path to any neighboring router.

This chapter provides procedures and examples for configuring OSPF using the NETCONF interface.

Refer to the Network OS Administrator’s Guide for the following related information:

• A conceptual overview of OSPF

• An overview of Designated routers

• Conceptual details about key configurable entities, such as stubs, stubby areas, not so stubby

areas, totally stubby areas, and virtual links

• Procedures for configuring the Ethernet management interface

You need an Ethernet management interface before you can configure a Secure Shell (SSH)

connection. As a result, you cannot begin a NETCONF session until this interface is configured.

• Procedures and examples for configuring OSPF using the Network OS command line interface

Using the NETCONF interface, you can perform the following OSPF configuration operations:

• Use the <edit-config> remote procedure call (RPC) to activate and deactivate OSPF globally, set

global OSPF parameters, activate and deactivate OSPF on a port, and to set interface

parameters on a specific port.

• Use the <get-config> RPC to verify all or part of the OSPF configuration.

OSPF parameters are defined in the brocade-ospf YANG module. For a structural map of the YANG

module, refer to the Network OS YANG Reference Manual. For definitions and explanations of all

OSPF parameters, refer to the brocade-ospf.yang file.

1 2 ... 546 547 548 549 550 551 552 553 554 555 556 ... 621 622

Komentáře k této Příručce

Žádné komentáře

Brocade Network OS NETCONF Operations Guide v4.1.1 Uživatelský manuál Strana 551

Komentáře k této Příručce

Související produkty a manuály pro Počítačové příslušenství Brocade Network OS NETCONF Operations Guide v4.1.1