
show ipv6 interface output descriptions TABLE 74
Field Description
Type Codes Shows the routing protocol enabled on the interface. The routing protocol can be one of the
following:
• R - RIP
• O - OSPF
Interface Shows the type, slot, and port number of the interface.
Stat/Prot Shows the status of the link and the protocol for the interface. The status can be one of the
following:
• Up
• Down
IGPs Shows the type of the Interior Gateway Protocols (IGPs) enabled on the interface.
IPv6 Address Shows the link local IPv6 address configured for the interface.
VRF Specifies the VRF to which the interface belongs.
Displaying IPv6 OSPFv3 interface information
IPv6 Interface information can be displayed in either a brief or full mode. The following sections
describe the command to display these modes and the resulting output:
• Displaying IPv6 OSPFv3 Interface Information in Brief Mode
• Displaying IPv6 OSPFv3 Interface Information in Full Mode
Displaying IPv6 OSPFv3 interface information in brief mode
You can use the following command to display a summary of IPv6 Interface information.
device# show ipv6 ospf interface brief
Interface Area Status Type Cost State Nbrs (F/C)
eth 1/1 0 up BCST 1 DROther 1/1
loopback 1 0 up BCST 1 Loopback 0/0
Syntax: show ipv6 ospf interface brief
show ipv6 ospf interface brief output descriptions TABLE 75
This field Displays
Interface The interface type, and the port number or number of the interface.
Area The OSPF area configured on the interface.
Displaying IPv6 OSPFv3 interface information
356 FastIron Ethernet Switch Layer 3 Routing Configuration Guide
53-1003087-04
Komentáře k této Příručce