Brocade FastIron Ethernet Switch Layer 3 Routing Configura Uživatelský manuál Strana 372

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 672
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 371
show ipv6 ospf virtual-neighbor output descriptionsTABLE 85
This field Displays
Index An index number associated with the virtual neighbor.
Router ID IPv4 address of the virtual neighbor.
Address The IPv6 address to be used for communication with the virtual neighbor.
State The state between the device and the virtual neighbor. The state can be one of the following:
Down
Attempt
Init
2-Way
ExStart
Exchange
Loading
Full
Interface The IPv6 address of the virtual neighbor.
Option The bits set in the virtual-link hello or database descriptors.
QCount The number of packets that are in the queue and ready for transmission. If the system is stable, this
number should always be 0.
Timer A timer that counts down until a hello packet should arrive. If "timers" elapses and a hello packet has
not arrived, the VL neighbor is declared to be down.
IPsec examples
This section contains examples of IPsec configuration and the output from the IPsec-specific show
commands. In addition, IPsec-related information appears in general show command output for
interfaces and areas.
The show commands that are specific to IPsec are:
show ipsec sa
show ipsec policy
show ipsec statistics
The other show commands with IPsec-related information are:
show ipv6 ospf area
show ipv6 ospf interface
show ipv6 ospf vrf
Showing IPsec security association information
The show ipsec sa command displays the IPSec security association databases, as follows.
device#show ipsec sa
IPsec examples
372 FastIron Ethernet Switch Layer 3 Routing Configuration Guide
53-1003087-04
Zobrazit stránku 371
1 2 ... 367 368 369 370 371 372 373 374 375 376 377 ... 671 672

Komentáře k této Příručce

Žádné komentáře