
Brocade Mobility RFS7000-GR Controller CLI Reference Guide 311
53-1001945-01
Chapter
12Interface Instance
In this chapter
•Interface Config commands . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 311
Use
the (config-if) instance to configure Fast Ethernet (fe), Giga Ehternet (ge), StaticAggregate
interface (sa), VLAN and tunnel . Use the
(config)# interface [fe|ge|sa|tunnel|vlan] to
reach this instance.
Interface Config commands
The following table summarizes the config-if commands.
TABLE 9 Interface config commands
Command Description Ref.
clrscr Clears the display screen. page 312
description Interface specific description. page 313
duplex Defines the duplex mode of operation. page 314
end Ends the current mode and moves to the EXEC mode. page 315
exit Ends the current mode and moves down to the previous mode. page 316
help Describes the interactive help system. page 317
ip Configures an IP address for the assigned Ethernet, VLAN or tunnel. page 318
mac MAC interface commands to configure MAC access list to a gigabit
ethernet interface.
page 320
management Sets the selected interface as the management interface. page 321
mtu Sets the mtu value for the VLAN interface. page 322
no Negates a command or sets defaults. page 323
port-channel Configures the load-balancing criteria of a aggregated port. page 324
service Displays service commands. page 325
show Shows the running system information. page 326
shutdown Shuts down the selected interface. page 328
spanning-tree Configures spanning-tree. page 329
speed Configures speed. page 331
static-channel-group Configures static channel commands. page 332
switchport Sets switching mode characteristics. page 333
tunnel Configures protocol-over-protocol tunneling. page 335
Komentáře k této Příručce