Brocade Mobility RFS7000-GR Controller CLI Reference Guide Uživatelský manuál stáhnout pdf (Strana 328)

100

101

314 Brocade Mobility RFS7000-GR Controller CLI Reference Guide

53-1001945-01

Interface Config commands

duplex

Interface Config commands

Use this command to specify the duplex mode of operation.

NOTE

- Duplexity can only be set for an Ethernet type interface. Enter the (config-if) instance using an

ge/me parameter in an interface mode.

- Duplex cannot be set until the speed is set to a non-auto value.

Syntax

duplex(auto|full|half)

Parameters

Usage Guidelines

Duplex defines the type of communication used by the port. The switch, by default, is set as

auto

duplex. In auto mode the duplex is selected based on the connected network hardware.

Example

RFS7000(config)#interface ge4

RFS7000(config-if)#duplex ?

auto set auto-negotiate

full set full-duplex

half set half-duplex

RFS7000(config-if)#duplex full

RFS7000(config-if)#

auto Sets the auto-negotiate parameter. Port is in full-duplex mode.

full Sets full-duplex where data can be passed in both direction simultaneoulsy.

half Sets half-duplex where data can only be passed in one direction at a time.

1 2 ... 323 324 325 326 327 328 329 330 331 332 333 ... 606 607

Komentáře k této Příručce

Žádné komentáře

Brocade Mobility RFS7000-GR Controller CLI Reference Guide Uživatelský manuál Strana 328

Komentáře k této Příručce

Související produkty a manuály pro Počítačové příslušenství Brocade Mobility RFS7000-GR Controller CLI Reference Guide