Brocade Multi-Service IronWare Switching Configuration Gui Uživatelský manuál stáhnout pdf (Strana 244)

100

101

214 Multi-Service IronWare Switching Configuration Guide

53-1003036-02

Displaying multi-port static MAC address information

Error: port 4/11 is part of multiport-mac and cannot be added as secondary

port of a trunk

• When a LAG primary port is part of a multi-port static MAC address, the LAG cannot be

undeployed or deleted. Also, when a non-LAG port is part of a multi-port static MAC address,

you cannot deploy a LAG with that port. These configurations will be rejected. The following are

the sample error messages for each of these cases:

- Veto check for deploying LAG.

Brocade(config-lag-LAG1)#deploy

Error: LAG LAG1 primary port 4/11 is configured as part of a multi-port mac

entry, cannot deploy the LAG

- Veto check for undeploying LAG.

Brocade(config-lag-LAG2)#no deploy

Error: The primary port 4/15 is configured as part of a multi-port mac

entry, cannot undeploy the LAG

- Veto check for deleting LAG.

Brocade(config)#no lag LAG2

Error: The primary port 4/15 is configured as part of a multi-port mac

address, cannot remove the LAG

• A port belonging to a multi-port static MAC address is not allowed to be removed from a VLAN

unless it is removed from all the multi-port static MAC addresses.

Brocade(config-vlan-100)#no tag e 2/19

Error - port 2/19 is configured as part of a multi-port mac address, cannot

remove port from vlan

• Module configuration deletion (no module) will be rejected if any of the ports in that module

are configured as part of any multi-port static MAC addresses.

Brocade(config)#no mod 4 ni-mlx-20-port-1g-100fx

Error - module 4 has ports that are member of the multi-port mac addresses,

Cannot remove the module

Displaying multi-port static MAC address information

You can display the following information about multi-port static MAC addresses on the device:

• Running configuration

• Changes in the MAC table

• M-port debug information

• LP information

Displaying running configuration

To display the running configuration information of multi-port static MAC addresses, enter the

following command.

Brocade# show run

vlan 10

tagged ethe 1/1 to 1/20 ethe 2/1 to 2/48

static-mac-address 0100.5e42.7f40 multi-ports ethe 1/1 to 1/3

1 2 ... 239 240 241 242 243 244 245 246 247 248 249 ... 983 984

Komentáře k této Příručce

Žádné komentáře

Brocade Multi-Service IronWare Switching Configuration Gui Uživatelský manuál Strana 244

Komentáře k této Příručce

Související produkty a manuály pro Počítačové příslušenství Brocade Multi-Service IronWare Switching Configuration Gui