Brocade Network OS Command Reference v4.1.0 Uživatelský manuál Strana 119

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 141
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 118
Network OS Command Reference 81
53-1003115-01
cisco-interoperability
2
cisco-interoperability
Configures the switch to interoperate with some legacy Cisco switches.
Synopsis cisco-interoperability {disable | enable}
Operands disable Disables Cisco interoperability for the Multiple Spanning Tree Protocol
(MSTP) switch.
enable Enables Cisco interoperability for the MSTP switch.
Defaults Cisco interoperability is disabled.
Command Modes Protocol Spanning Tree MSTP mode
Description Use this command to enable or disable the switch to interoperate with some legacy Cisco
switches. For some switches, the MSTP field Version 3 Length does not adhere to the current
standards.
Usage Guidelines If Cisco interoperability is required on any switch in the network, then all switches in the network
must be compatible, and therefore enabled using this command for interoperability with a Cisco
switch.
If xSTP is enabled over VCS, this command must be executed on all RBridge nodes.
Examples To enable Cisco interoperability on a switch:
switch# configure terminal
switch(config)# protocol spanning-tree mstp
switch(conf-mstp)# cisco-interoperability enable
To disable Cisco interoperability on a switch:
switch# configure terminal
switch(config)# protocol spanning-tree mstp
switch(conf-mstp)# cisco-interoperability disable
See Also None
Zobrazit stránku 118
1 2 ... 114 115 116 117 118 119 120 121 122 123 124 ... 140 141

Komentáře k této Příručce

Žádné komentáře