Network OS Command Reference 61
53-1003115-01
cee
2
cee
Applies a Converged Enhanced Ethernet (CEE) provisioning map on an interface.
Synopsis cee default
no cee
Operands None
Defaults There is no CEE provisioning applied on an interface. The only map name allowed is “default.”
Command Modes Interface subtype configuration mode
Description Use this command to apply an existing CEE map on a specific interface.
Usage Guidelines The CEE map applied on an interface should already exist on the switch.
Enter no cee to remove the CEE Provisioning map.
Examples To apply a CEE map to a specific 10-gigabit Ethernet interface:
switch(config)# interface tengigabitethernet 178/0/9
switch(conf-if-te-178/0/9)# cee default
See Also interface, cee-map (configuration), channel-group, dot1x authentication, dot1x port-control,
dot1x quiet-period, dot1x reauthentication, dot1x reauthMax, dot1x timeout re-authperiod,
dot1x timeout server-timeout, dot1x timeout supp-timeout, dot1x timeout tx-period,
edge-loop-detection vlan, edge-loop-detection port-priority
Komentáře k této Příručce