Brocade Mobility Access Point System Reference Guide (Supp Uživatelský manuál Strana 131

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 854
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 130
Brocade Mobility Access Point System Reference Guide 121
53-1003100-01
5
18. Refer to the following manual session configurations to determine whether a session should be
created or modified:
19. Select Add to create a new manual session, Edit to modify an existing session configuration or
Delete to remove a selected manual session.
FIGURE 37 Network - L2TPv3 screen, Add T2TP Peer Configuration
IP Address
Lists the IP address assigned as the local tunnel end point address, not the interface IP address.
This IP is used as the tunnel source IP address. If this parameter is not specified, the source IP
address is chosen automatically based on the tunnel peer IP address. This parameter is applicable
when establishing the session and responding to incoming requests.
Local Session ID
Displays the numeric identifier assigned to each listed tunnel session. This is the pseudowire ID for
the session. This pseudowire ID is sent in a session establishment message to the L2TP peer.
MTU
Displays each sessions’s maximum transmission unit (MTU). The MTU is the size (in bytes) of the
largest protocol data unit the layer can pass between tunnel peers in this session. A larger MTU
means processing fewer packets for the same amount of data.
Name
Lists the name assigned to each listed manual session.
Remote Session ID
Lists the remote session ID passed in the establishment of the tunnel session.
Zobrazit stránku 130
1 2 ... 126 127 128 129 130 131 132 133 134 135 136 ... 853 854

Komentáře k této Příručce

Žádné komentáře