Brocade Mobility Access Point System Reference Guide (Supp Uživatelský manuál stáhnout pdf (Strana 397)

100

101

Brocade Mobility Access Point System Reference Guide 387

53-1003100-01

Select the VLAN tab to display the link IP VLAN information shared by the access points managed

by the MINT configuration.

FIGURE 215 Device Overrides - Advanced Profile MINT screen - VLAN tab

The VLAN tab displays the VLAN, Routing Level, Link Cost, Hello Packet Interval and Adjacency Hold

Time managed devices use to securely communicate amongst one another.

Select Add to create a new VLAN link configuration or Edit to override an existing MINT

configuration.

NOTE

If creating a mesh link between two access points in Standalone AP mode, you’ll need to ensure a

VLAN is available to provide the necessary MINT link between the two Standalone APs.

Hello Packet Interval

Set or override an interval in either Seconds (1 - 120) or Minutes (1 - 2) for the transmission of

hello packets. The default interval is 15 seconds.

Adjacency Hold Time

Set or override a hold time interval in either Seconds (2 - 600) or Minutes

(1 - 10) for the transmission of hello packets. The default interval is 46 seconds.

IPSec Secure

Select this option to use a secure link for IPSec traffic. This setting is disabled by default. When

enabled, both the header and the traffic payload are encrypted.

IPSec GW

Define either an IP address or hostname for the IPSec gateway.

1 2 ... 392 393 394 395 396 397 398 399 400 401 402 ... 853 854

Komentáře k této Příručce

Žádné komentáře

Brocade Mobility Access Point System Reference Guide (Supp Uživatelský manuál Strana 397

Komentáře k této Příručce

Související produkty a manuály pro Počítačové příslušenství Brocade Mobility Access Point System Reference Guide (Supp