Brocade Mobility Access Point System Reference Guide (Supp Uživatelský manuál stáhnout pdf (Strana 193)

100

101

Brocade Mobility Access Point System Reference Guide 183

53-1003100-01

15. Refer to the following to determine whether a new Dynamic NAT configuration requires

creation, edit or deletion:

16. Select Add to create a new Dynamic NAT configuration, Edit to modify an existing configuration

or Delete to permanently remove a configuration.

FIGURE 82 Profile Security - Source ACL List screen

Source List ACL

Lists the ACL defining packet selection criteria for the NAT configuration. NAT is applied only on

packets which match a rule defined in the access list. These addresses (once translated) are not

exposed to the outside world when the translation address is used to interact with the remote

destination.

Network

Displays Inside or Outside NAT as the network direction for the dynamic NAT configuration.

Interface

Lists the VLAN (from 1 - 4094) used as the communication medium between the source and

destination points within the NAT configuration.

Overload Type

Lists the Overload Type used with the listed IP ACL rule. Options include NAT Pool, One Global

Address and Interface IP Address. The default setting is Interface IP Address.

NAT Pool

Displays the name of an existing NAT pool used with the NAT configuration.

Overload IP

Enables the use of one global address for numerous local addresses.

ACL Precedence

Lists the administrator assigned priority set for the listed source list ACL. The lower the value listed,

the higher the priority assigned to this ACL rule.

1 2 ... 188 189 190 191 192 193 194 195 196 197 198 ... 853 854

Komentáře k této Příručce

Žádné komentáře

Brocade Mobility Access Point System Reference Guide (Supp Uživatelský manuál Strana 193

Komentáře k této Příručce

Související produkty a manuály pro Počítačové příslušenství Brocade Mobility Access Point System Reference Guide (Supp