Brocade Mobility Access Point System Reference Guide (Supp Uživatelský manuál Strana 66

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 854
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 65
56 Brocade Mobility Access Point System Reference Guide
53-1003100-01
5
However, an access point’s RF Domain configuration may need periodic refinement from its original
RF Domain designation. Unlike a RFS series wireless controller, an access point supports just a
single RF domain. Thus, administrators should be aware that overriding an access point’s RF
Domain configuration results in a separate configuration that must be managed in addition to the
RF Domain configuration. Thus, a configuration should only be overridden when needed. For more
information, see RF Domain Overrides on page 5-242.
The access point’s RF Domain can have a WIPS sensor configuration applied. For more information
on defining a WIPS sensor configuration for use with the access point’s RF Domain, see RF Domain
Sensor Configuration on page 5-57.
To set a RF Domain configuration:
1. Select the Configuration tab from the Web UI.
2. Select Devices.
3. Select RF Domains from the options on left-hand side of the UI.
The RF Domain Basic Configuration tab displays by default with the access point RF Domain
activated.
FIGURE 1 RF Domain - Basic Configuration tab
Zobrazit stránku 65
1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 853 854

Komentáře k této Příručce

Žádné komentáře