Brocade Mobility Access Point System Reference Guide (Supp Uživatelský manuál stáhnout pdf (Strana 358)

100

101

348 Brocade Mobility Access Point System Reference Guide

53-1003100-01

Device Overrides - Add NAT Source screen

Define the following Source NAT parameters:

Protocol

Select the protocol for use with static translation. TCP, UDP and Any are the available options.

Transmission Control Protocol (TCP) is a transport layer protocol used by applications requiring

guaranteed delivery. It’s a sliding window protocol handling both timeouts and retransmissions. TCP

establishes a full duplex virtual connection between two endpoints. Each endpoint is defined by an

IP address and a TCP port number. The User Datagram Protocol (UDP) offers only a minimal

transport service, non-guaranteed datagram delivery, and provides applications direct access to the

datagram service of the IP layer. UDP is used by applications not requiring the level of service of TCP

or are using communications services (multicast or broadcast delivery) not available from TCP. The

default setting is Any.

Source IP

Enter the address used at the (internal) end of the static NAT configuration. This address (once

translated) will not be exposed to the outside world when the translation address is used to interact

with the remote destination.

1 2 ... 353 354 355 356 357 358 359 360 361 362 363 ... 853 854

Komentáře k této Příručce

Žádné komentáře

Brocade Mobility Access Point System Reference Guide (Supp Uživatelský manuál Strana 358

Komentáře k této Příručce

Související produkty a manuály pro Počítačové příslušenství Brocade Mobility Access Point System Reference Guide (Supp